Lighted Spinning Jewelry Stand
• Battery Cube
• Motor Cube
• LED Cube
• Medium wire (2)
• 4 x 8 plate (2)
• 4-stud brick
• 16-stud brick (2)
• Full connector
• 3/4 connector (2)
• Scotch tape
Use building bricks and Circuit Cubes to make a spinning, lighted stand that shows off all of your amazing jewelry — or whatever else you want to take for a spin!
1 Gather your Cubes, building bricks, and other materials.
2 Gather the two 4 x 8 plates.
3 Attach the two 16-stud-long bricks on top of them.
4 Put the full connector into the four-stud-long brick.
5 Stick the connector and the four-stud long brick into the end of the 16-stud long one.
6 Connect the wheel to the Motor Cube.
7 Gather the tape, 8x8 plate, the Motor Cube, and wheel from the last step.
8 Use the tape to attach the plate to the wheel.
9 Put the two three-quarter connectors into the other 16-stud-long brick.
10 Stick the Motor on top of the three-quarter connectors and get the Motor Cube and Light Cube.
11 Stack the Light Cube onto the Battery Cube, and use the two wires to connect the two.
12 Put the Battery Cube onto the four-stud-long brick. Place earrings, rings, or anything else you'd like to display on top, turn the Battery Cube on, and watch the stately circle of your fancy things as they go 'round and 'round.